Steel Shaft,Cold Shaft,Cold Steel Shaft,Spear Shaft Qufu Zhuoyue Heavy Industry Science&Technology Co., Ltd , https://www.zhuoyueindustry.com
During the use of the round-type inspection flat screen, the instrument can run but the noise is too large. What is the reason? How can we solve it? So here to talk about the possible causes and maintenance methods of this situation.
1. There are one or more screws in the three-bar linkage. The screws should be tightened. 2. After a certain period of time, the clearance of the small E18 connecting rod bearing increases. It should be replaced. 3. After a period of time, the inner diameter of the connecting rod Bearing Seat becomes larger. , should be replaced 4. Fixed connecting rod bearing screws loose, should be tightened screws, respectively Round test flat screen shows the symptoms may be the power indicator light is not bright, then the most likely reason is that the power connector plug is bad This is where it should be checked and replaced.
The instrument for checking the fineness of flour is the most prominent among the circular inspection flat sieves. The thickness of the flour directly affects the quality of the flour. There is also a requirement for the thickness and fineness of the flour. It also has a certain influence on the detection results. Therefore, the round inspection screen is Powder detection is an important instrument and equipment. The principle is that the sample is sieved on different specifications of sieves to achieve different particle separation. Calculate the thickness of powdered grain according to the amount of residue on the screen.