Description of Adjustable manual vacuum suction crane: The product can load of 600 kg.
It can be used without external power supply. The suction, release and rotation of the suction cup are all controlled by remote control. Each suction cup has a separate switch which can be used as required, and the suction cup holder has a telescopic rod which can be installed or removed as required. The equipment and electrical components are manufactured by the Schneider brand of France, and the vacuum pressure control adopts the German Festoon brand, the electromagnetic valve and the pressure gauge and the filter adopts the Japan SMC, the remote controller adopts the Taiwan Yuding brand, and the gas pipe adopts the German Festoon and the Taiwan Airtac brand, and the sucker is a silicone suction cup.
Glass Lifter,Suction Lifter,Glass Lifting Equipment,Glass Lifter Suction Cup JINAN KATION TRADING CO.,LTD , https://www.machinerychinese.com
1, check before installation Pneumatic butterfly valve parts of all parts without missing, the model is correct, check the valve body without debris, solenoid valves and silencers within the block 2, the valve and the cylinder are placed in the closed state. 3, the cylinder hit the valve, (installation direction and the valve body parallel or vertical can), look at the screw hole is correct, there will not be too much deviation, if there is a slight deviation, the cylinder body can rotate a little , Then tighten the screws. 4, after the installation, the pneumatic butterfly valve for debugging (under normal circumstances, the supply pressure of 0.4 ~ 0.6MPa), commissioning and operation of the solenoid valve to be opened and closed manually (the solenoid valve power after the loss of manual operation can be effective) Watch the pneumatic butterfly valve opening and closing situation. If found in the process of commissioning the valve opening and closing process at the beginning of a bit strenuous, then normal, you need to adjust the cylinder stroke (the cylinder stroke adjustment screw at the same time in the tune of a little adjustment will be required to run the valve to the open position , And then turn off the gas source) until the valve opening and closing movements smooth and closed without leakage. It should also be noted that the adjustable muffler can adjust the valve opening and closing speed, but not too small, otherwise it may cause the valve does not move. 5, hair should be kept dry before installation, can not be stored in the open air 6, before installing the butterfly valve to check the pipeline to ensure that there is no weld slag and other foreign matter in the pipeline 7, butterfly valve body manual opening and closing resistance moderate, butterfly valve torque and the selected actuator torque match. 8, butterfly valve flange with the correct specifications, pipe flange on the folder flange and butterfly valve standard. It is recommended to use butterfly valve special flange, not to use flat welding flange. 9, confirm the flange welding is correct, the butterfly valve can not be welded after installation flange, so as not to scald rubber parts. 10, fitted pipe flange to be carried out in the center, and put into the butterfly valve. 11, fitted with all the flange bolts, and tighten the hand, will confirm the butterfly valve and the flange is already centered, and then open and close the valve carefully, to ensure that the opening and closing flexible. 12, the valve is fully open, with a wrench diagonal bolt tightening, no washer, do not bolt too tight, to prevent serious deformation of the valve ring, opening and closing torque is too large.