The composition of the biaxial dust humidifying mixer mainly consists of the housing, the screw shaft assembly, the speed reducer, the motor, the cover plate, the chain cover, and the humidifying water spray system. Feeding from the top and discharging at the bottom, it can evenly stir various materials at the same time when delivering dust. For flying dust, adding an adjustable water supply system to atomize spray can complete the process of material collection and transportation. Avoid dust pollution of the environment. Biaxial dust humidification mixer has the advantages of reasonable structure, uniform humidification, moderate water adjustment, good equipment sealing, reliable and stable work, low noise, large amount of processing, low maintenance, and long service life, so that dust does not dry out when it is humidified. The purpose of the ash is not to seep the water droplets, and it is convenient for loading and transporting dust or transferring to other conveying equipment. Dust-wet mixer is mainly applied to thermal power plants, metallurgy, chemical industry, building materials, mining and other industries, in order to meet the requirements of environmental protection and transport. The frequent inspection of the double-shaft dust and humidification mixer should be done immediately after use. If abnormal noise, vibration, rapid temperature rise, etc., the machine should be shut down immediately for inspection and troubleshooting. In order to ensure the efficient operation of the dust-moisturizing mixer and achieve satisfactory economic results, regular maintenance and maintenance must be carried out. Biaxial dust humidification mixer technical parameters: Model Item SJ-10 SJ-20 SJ-40 SJ-60 SJ-80 SJ-100 SJ-200 Processing capacity T/H 10 20 40 60 80 100 200 Helical diameter MM Φ400 Φ400 Φ600 Φ600 Φ700 Φ700 Φ800 Spindle speed RPM 34 34 34 34 34 34 34 Reducer model XWD4-5-1/43 XWD5.5-6-1/43 XWD11-8-1/43 XWD15-9-1/29 XWD8.5-9-1/29 XWD22-10-1/29 XWD30-11-1/29 Motor power kw 4.0 5.5 11 15 18.5 twenty two 30 Water Pressure MPA 0.4-0.8 Moisture content % 15-20 (It can also be customized according to the requirements of the installation environment of other models and materials of dust humidification mixer) Details Reference dust humidifier equipment / service hotline 0317 to 5569122 copper fittings approved WRAS,DVGW,SABSS,UPC,NSF61,covered EN1254-1 and ASME B16.22,copper fittings,copper pipe fittings,copper plumbing fittings,copper capillary fittings,copper pressure fittings copper fittings,copper pipe fittings,copper plumbing fittings,copper capillary fittings,copper pressure fittings Taizhou Runde Company , https://www.zjcopperfittings.com
Biaxial dust humidifier , dust humidifier, dust humidifier is a new type of dust humidification mixing and conveying equipment. The dust enters the housing through the feed inlet through the rigid impeller feeder. Two symmetrical screw shafts drive the wear-resistant The alloy blades or ceramic blades are rotated synchronously, and the dust is humidified, stirred and conveyed to the discharge port, and the moisture content of the dust is controlled by adjusting the amount of water supply.