The UV aging test chamber uses a fluorescent UV lamp as a light source to simulate the material by simulating ultraviolet radiation and condensation in natural sunlight, so it is especially important for the maintenance of the UV aging test machine. Let's take a look at it. Some maintenance knowledge! as follows: In order to make the UV aging tester work better and maintain good condition for a long time, please maintain it according to the following items: 1. If the UV aging tester is in a non-working condition, keep it dry and disconnect the power supply. 2. After the test, drain the water inside the test machine and dry the studio and the cabinet. 3. After use, remember to put the plastic cover on it to avoid dust intrusion. If there is dust, it should be removed in time. 4. The sensing device in the working room should not be subjected to strong impact; 5, UV aging test chamber Zui is placed in a well ventilated place (recommended to install ventilation fan, keep indoor ventilation), should not be installed in dusty places; 6. If the UV aging test chamber fails and cannot be eliminated, please look for the relevant personnel, do not disassemble it; 7. The test box is not used for a long time. If it is used again, the water source, power supply and various components must be carefully checked. Start the UV aging test chamber; 8. The operator is equipped with protective eyepieces and sheaths. Because ultraviolet radiation has a strong hazard to personnel (especially the eyes), the operator should minimize exposure to ultraviolet light (contact time should be <1min); 9. Prohibit the exposure of chemicals to the UV aging test chamber; (away from combustibles and explosives); 10. The wastewater discharge system of the UV aging test chamber must be installed in place; 11. After each test, the sample should be taken out and the inner liner of the UV aging test chamber cleaned up; 13. After use, remember to put the plastic cover on it. If there is dust, it should be removed in time to keep the appearance of the box clean and avoid dust from entering the box. Stacking Machine,Automatic Material Collection Stacking Machine,Hardware Collection Equipment,Material Collection Equipment Dongguan City Li you machinery and Equipment Co., Ltd. , https://www.gdliyou.com
The UV aging test chamber uses a fluorescent UV lamp as a light source to simulate the weathering resistance of the material by simulating ultraviolet radiation and condensation in natural sunlight to obtain the weather resistance of the material. It can simulate environmental conditions such as ultraviolet, rain, high temperature, high humidity, condensation, and darkness in natural climate. By recreating these conditions, they are combined into one cycle and automatically executed to complete the cycle. maintenance